Great Plains 3S-4000F Operator Manual - Manual (Page 51)

Great Plains Manufacturing, Inc. Table of Contents Index Operating Instructions 47
2014-06-10 Table of Contents Index 195-394M
Pulses Per Mile
Press the FUNC button until the “PULSES” icon appears
in the display. The number in the display indicates how
many times the shaft rotates for every mile driven.
There are 2 methods to enter the pulses per mile:
Refer to Figure 48
A. If you know the number, select it using the UP and
DOWN buttons. When you press the FUNC button,
the acremeter accepts the number in the display as
the new pulses per mile.
Refer to Figure 49
B. If you do not know the pulses per mile, press and
hold the UP and DOWN buttons until “0000” appears
in the display. The “COUNT” icon will appear. The
acre counter is now counting shaft rotations. Enter
the cab and drive one mile. Press the FUNC button
to wake up the acre counter. The “PULSES” and
“COUNT” icons will re-appear. The number
displayed is the pulses per mile. Press the FUNC
button to accept the setting. The “COUNT” icon will
disappear. If you could not drive a mile, you can
calculate the pulses per mile using a formula.
Note: If a password is set, you will not be able to adjust
the pulses per mile.
Width
Refer to Figure 50
Press the FUNC button until the “WIDTH” icon appears
in the display. The number displayed is the width of your
implement in feet.
To adjust the width, press the UP and DOWN buttons. If
a password has been entered, you will not be able to
adjust the width.
The width can be adjusted from 0 to 99.9 feet, in tenths
of a foot.
Figure 48
Pulses per Mile
PULSES
Figure 49
Reset for New Count
PULSES
CNT
pulse count
distance in miles
pulses per mile =
Figure 50
Enter Swath
WIDTH
FT