Great Plains 3P4025AH Operator Manual - Manual (Page 22)

18 3P4025AH Table of Contents Index Great Plains Manufacturing, Inc.
411-099M Table of Contents Index 2014-07-29
Raise Parking Stands
Refer to Figure 6
1.
If not already at minimum length, remove lower
pin
of parking stand, fully retract the inner leg ,
and re-insert pin.
2. Remove upper (holding) pin of parking stand (at
bottom of hinge bracket)
Refer to Figure 7
Crushing or Impact Injury Hazard:
Do not stand directly in front of the stand while raising it. You
need to have one hand free to insert the pin, and if you lose
your grip on the stand, it can swing down and inflict injury.
3. Swing the parking stand forward and up until it is
above the rear hole. Place the holding pin
in the
rear-most (or top-most
a
) top hole of the hinge
plate. This is the parking stand position for transport
and field operation.
4. If the planter is equipped with row cleaners, the
stand may not be able to get fully vertical. It may be
necessary to use front top hole
.
a. Depending on the row spacing, if row cleaners and/or unit-mounted coulters are installed, there may be interference between row
components and a fully vertical parking stand. If so, use the forward (top-most) top hole, and secure the stand angled slightly forward.
Figure 6
Raising Parking Stand
25240
1
2
3
4
1 2
3
1
4
5
Figure 7
Parking Stand Raised
25241
5
4