Great Plains 3P4025AH Operator Manual - Manual (Page 9)

Great Plains Manufacturing, Inc. Table of Contents Index Important Safety Information 5
2014-07-29 Table of Contents Index 411-099M
Safety Decals
Safety Reflectors and Decals
Your implement comes equipped with all lights, safety
reflectors and decals in place. They were designed to
help you safely operate your implement.
▲ Read and follow decal directions.
▲ Keep lights in operating condition.
▲ Keep all safety decals clean and legible.
▲ Replace all damaged or missing decals. Order new decals
from your Great Plains dealer. Refer to this section for
proper decal placement.
▲ When ordering new parts or components, also request
corresponding safety decals.
Transport Decals
818-055C
Slow Moving Vehicle Reflector
On center rear face of center frame tie tube;
1 total
838-266C
Red Reflectors
Placements vary by machine configuration. Red
reflectors are above daytime reflectors.
• On the rear face of outboard center section hoppers.
• On the rear outboard face of wing tool bars, where not
obscured by row hoppers - or- on the rear face of
outboard row hoppers, where those hoppers obscure
the wing tool bars.
• On the rear face of the lift-assist caster weldments, if
lift-assist present.
4 or 6 total
To install new decals:
1. Clean the area on which the decal is to be placed.
2. Peel backing from decal. Press firmly on surface,
being careful not to cause air bubbles under decal.
36093
36093