Great Plains TC5319 Assembly Manual - Manual (Page 30)

26 TC5109-5323 Table of Contents Index Great Plains Manufacturing, Inc.
566-046E Table of Contents Index 04/12/2012
Completing Setup
131.Be sure all bolts are tightened to specs, See
“Torque Values Chart” on page 27
132.The decals may now be installed.
133.See appropriate pages for decals in the “Parts and
Operator’s Manual” for decal placement.
134.To install new decals:
a.Clean the area on which the decal is to be placed.
b. Peel backing from decal. Press firmly on surface,
being careful not to cause air bubbles under decal.
135.If machine has an optional finishing attachment or,
refer to the “Parts Manual” for parts break down and
attachment layout drawings of this manual.
If machine is equipped with a rear attachment, be sure you
install the optional rear jack stand, see “Parts Manual (Rear
Jack Stand) so machine doesn’t tip backwards when unhooking
machine from tractor.
136.Once the options are installed and all of the hydrau-
lic procedures have been completed, you may fold
and raise/lower the machine to check for clearance
and interferences.
137.Be sure to consult the operating instructions, “Oper-
ator’s Manual”, for the first time field adjustments
before going to the field.