Great Plains TC5319 Assembly Manual - Manual (Page 29)

Great Plains Manufacturing, Inc. Table of Contents Index Assembly 25
04/12/2012 Table of Contents Index 566-046E
Lights
Refer to Figure 28
Note: See machine layout section for proper light bracket
placement.
124.Fasten light bracket LH to center frame with 1/2 x 4
1/32 x 7 1/4 u-bolts , 1/2 lock washers and 1/2 huts.
Repeat same procedure for light bracket RH .
125.Route light harness 30’ lead from front of hitch (trac-
tor plug to front), along same route as hydraulic hose
(fasten in same clamps and hose wraps as hoses).
Plug one end of enhance light module
to small end of
light harness 30’ lead . Plug bigger end of wishbone
light harness into other end of enhance light module
. Route other ends over towards (marked left and
right) the light mounting brackets as shown.
126.Mount red lamp lights to mounting plates of wing
stop or rigid smv and light bracket, with 1/4 x 1 hex
bolts
and 1/4 lock nuts.
127.Mount amber lamp lights to top of light brackets
and , with 1/4 x 1 hex bolts and 1/4 lock nuts.
128.Tighten all bolts to specs, See “Torque Values Chart”
on page 27. Be sure and get all wiring harnesses fas-
tened up securely with hose wraps or clamps (if routed
close to hydraulic hoses) or use cable ties
.
Install Rear Hitch (optional)
Note: The rear tow hitch will be shipped with big compo-
nents banded together and bolts will be in a box.
Carefully un-band the components.
Refer to Figure 29
129.Attach rear hitch trusses
to rear of hitch arms with
3/4 x 2 1/2 hex bolts , 3/4 lock washers and 3/4 nuts.
Attach middle of rear hitch arms to tubes on center
frame with 3/4 x 4 1/32 x 7 1/2 u-bolts
, 3/4 lock
washers and 3/4 nuts.
130.Attach 56” cross arm to bottom side of rear hitch
arm plates with 5/8 x 3 1/32 x 4 1/2 u-bolts , secure
with 5/8 lock washers and 5/8 nuts.
Note: Do not tighten any bolts until every thing is installed.
Note: The bolt on sleeve assembly with rigid or flex slide
may be fastened using 5/8 x 3 1/32 x 4 1/2 u-bolt ,
secure with 5/8 lock washers and 5/8 nuts.
Note: Tighten all bolts to specs, See “Torque Values
Chart” on page 27.
Note: If machine is equipped with optional rear hitch acces-
sory kit may be installed as shown in “Parts Manual”.
Note: Route hoses and light harness along hitch and frame
with hose clamps and hose wraps, provided.
Note: Be sure hoses and light harness is fastened securely
so they don’t drag or get pinched.
Figure 28
Lights
42636
3
9
9
5
1
7
9
8
9
U
D
F
B
L
R
4
8
6
2
6
10
1
3
2
4
5
4
6
5
7
9
8 1
2 9
10
Figure 29
Rear Hitch
42648
1
2
5
3
4
6
6
1
2
3
4
5
6
5