Trusses – Great Plains TC5319 Assembly Manual User Manual
Page 14
10
TC5109-5323
Great Plains Manufacturing, Inc.
566-046E
04/12/2012
Trusses
Refer to Figure 9
Note: Do not tighten any bolts until all parts are assem-
bled.
34. Start by bolting the rear of the LH
and RH
trusses to center frame using 1 1/4 x 8 1/2 Gr. 8 hex
bolts
, 1 1/4 lock washers and 1 1/4 nuts. Attach
middle plates of trusses with 3/4 x 2 1/2 hex bolts
,
3/4 lock washers, 3/4 nuts, front plates with 3/4 x 2
3/4 lock washers, and 3/4 nuts.
35. Mount the manual pack
to RH truss
plate with 1/
4 x 3/4 pan screws
, mini end press wheels
, 1/4
lock washers and 1/4 nuts.
36. Models 5317-5323, attach the bypass valve
to the
RH truss
with 5/16 x 3 hex bolts
, 5/16 lock
washers and 5/16 nuts.
37. Models 5317-5323, install the rebound valve plate
with two 3/4 x 3 hex bolts
, 3/4 lock washers, 3/4
nuts.
38. Models 5317-5323, install the pilot operated check
valve
to rebound valve plate
with 5/16 x 1 3/4
hex bolts
, 5/16 lock washers, 5/16 nuts
39. All bolts may be tightened to specs, See “Torque
1
2
3
4
5
6
2
7
8
9
2
10
11
12
13
11
14