Great Plains 3S-5000HD Assembly Instructions - Manual (Page 31)

Great Plains Manufacturing, Inc. Table of Contents Index Installation Instructions 27
2013-07-30 Table of Contents Index 133-415M
Right Box End Fittings
Refer to Figure 42, which depicts the left section box.
112. Select two sets saved:
803-169C NUT HEX FLG LOCK 1/2-13 PLT
802-203C HFSS 1/2-13X1 1/2 GR5
or HHCS bolts, flat washers and plain nuts.
113. Select one new:
123-492D HANDLE MOUNT RH CHAIN GUARD
Position it on the small seed box drive
mount.Secure with bolts
, nuts and washers
(if any).
Note: There are no other fittings at this location.
Repeat step 109 through step 113 for the center and
right sections. Additional new and saved fittings to be
installed are:
• Center Section, Left End:
1 123-491D HANDLE MOUNT LH CHAIN GUARD
2 804-016C WASHER FLAT 1/2 SAE PLT
1 195-417D (LH) 15’3SMT LIGHT BRACKET (LH)
• Center Section, Right End:
1 123-492D HANDLE MOUNT RH CHAIN GUARD
2 804-016C WASHER FLAT 1/2 SAE PLT
1 195-417D (RH) 15’3SMT LIGHT BRACKET (RH)
• Right Section, Left End:
1 123-491D HANDLE MOUNT LH CHAIN GUARD
1 119-190D HANDLE
• Right Section, Right End:
1 123-492D HANDLE MOUNT RH CHAIN GUARD
1 119-190D HANDLE
Install Meter Shaft Chains
Start with the left section.
Refer to Figure 43, which is depicted with obscuring parts
removed. Gray arrows show direction of chain motion.
114. Select one new:
136-104D CHAIN RL #40 62 PITCHES
115. Route chain around lower jackshaft driving
sprocket, around upper final meter shaft sprocket,
and forward of idler
.
Make sure chain clip opening faces away from
direction of chain motion. See Figure 25 on
page 17.
116. Engage idler arm and tighten bolt when longest
span of chain has
1 ⁄
4
inch (6 mm) slack.
Repeat step 114 through step 116 for the center and
right sections.
U
D
L
R
B
F
112
22
18
Figure 42:
Mount RH Guard, Corner Fittings
27435
22
18
112
18 22
111
26
12
112
26
13
111
11
112
11
U
D
L
R
B
F
175
1
2
Figure 43:
Final Drive Chain
27436
175
175
1
2