Great Plains 3S-5000HD Assembly Instructions - Manual (Page 10)

6 3S-5000/F/HD/HDF SGS Table of Contents Index Great Plains Manufacturing, Inc.
133-415M Table of Contents Index 2013-07-30
Remove Corner Hardware
Left Section Corner Hardware
Refer to Figure 4
10. Remove and save two pairs of:
803-169C NUT HEX FLG LOCK 1/2-13 PLT
802-203C HFSS 1/2-13X1 1/2 GR5
and one each:
119-190D HANDLE
248-251D MANUAL PAK MOUNTING PLATE
Note: Do not further disassemble the manual pak .
Center Section Corner Hardware
Refer to Figure 5 (depicting the LH corner)
11. At the left end of the center section seed box,
remove and save two sets of:
803-169C NUT HEX FLG LOCK 1/2-13 PLT
802-203C HFSS 1/2-13X1 1/2 GR5
four pairs (8 total):
804-016C WASHER FLAT 1/2 SAE PLT
and one:
195-417D (LH) 15’3SMT LIGHT BRACKET (LH)
Mark the assembly as “LH” when removed.
12. Repeat step 11 for the right corner and:
195-417D (RH) 15’3SMT LIGHT BRACKET (RH)
Mark the assembly as “RH” when removed.
Note: Do not further disassemble the lights ( , ).
Their cables may be left connected if there is
convenient location to position them during the
remainder of the installation.
Right Section Corner Hardware
Refer to Figure 6
13. Remove and save two pairs of:
803-169C NUT HEX FLG LOCK 1/2-13 PLT
802-203C HFSS 1/2-13X1 1/2 GR5
and one:
119-190D HANDLE
22
22
18
18
15
11
U
D
F
B
L
R
Figure 4:
Left Section Corner Hardware
27431
22
18
11
15
15
U
D
F
B
L
R
22 26
12
18
Figure 5:
Center Section Corner Hardware
34243
22
18
26
12
13
22
22
18
18
11
U
D
F
B
L
R
Figure 6:
Right Section Corner Hardware
27431
12 13
22
18
11