Canon elura20 - Manual (Page 79)

79
E
Using the Full Range of Features
Returning to a Pre-Marked Position
Use the wireless controller to mark a point on a tape that you want to return to
following playback.
1. Press the ZERO SET MEMORY button on the wireless controller
during playback at a point you want to return to later.
• The time code is replaced by a tape counter that is set to zero with the
Â
indication.
• Press the ZERO SET MEMORY button once more to cancel the zero set
memory.
2. When you have finished playback, fast forward or rewind the tape.
The tape stops automatically when it reaches the zero set position.
• RTN
1 or `RTN appears in the display.
• The tape counter with
 indication disappears from the display and the time
code reappears.
• The zero set memory may not function correctly where there is a break between
recordings on the tape.
• You can also use zero set memory to mark a position on a tape in camera mode.
When you then play back the tape, pressing rewind will take you back to the
pre-marked position.
• If you remove the tape while the zero set memory is set, the memory is
canceled and the tape counter reverts to time code.
• The camera remembers your setting even if you turn it off and back on again or
move the program selector.
REW PLAY FF
SEARCH
SELECT
ZERO SET
MEMORY
AUDIO
DUB.
STOP
A/V
INSERT
PAUSE SLOW ×2
+ / – /
REMOTE
OFF
PO WER VCR
P.SCAN MOV
IE
MOVIE P.SCAN VCR