Canon elura20 - Manual (Page 114)

114
E
Using a Memory Card
(ELURA20 MC only)
4. Select the desired setting.
• Your currently recording image is combined with the pre-recorded still
image.
5. Select MIX LEVEL.
6. Adjust the mix level.
• Turning the SELECT dial upwards adjusts to the right and turning
downwards adjusts to the left.
7. Close the menu.
• CARD MIX flashes in the display.
8. Press the card MIX button.
• CARD MIX stops flashing.
• Your currently recording image is combined with the pre-recorded still
image.
• Each time you press the card MIX button, your selection is activated
(display lights continuously) or deactivated (display flashes).
1. Press the start/stop button to start and stop recording.
• The combined images are recorded onto the cassette.
1. Press the PHOTO button halfway down and hold it.
•
F flashes white in the display as the camera adjusts the focus and it is
displayed continuously as a green mark when the camera is ready to take the
image.
2. Press the PHOTO button fully down to record the image to the
cassette.
•
F disappears from the display.
• The combined images are recorded onto the cassette for approximately 6
seconds (8 seconds in the SP or LP recording mode).
• You cannot use Card Mix in the Low Light recording program (in MOVIE and
P.SCAN modes).
• If you change the position of the POWER dial or move the program selector
from
Q
to
[ Easy Recording mode, select your still image for Card Mix
again.
• When setting Card Mix, you must carry out steps 1 to 5.
For a still image
For a moving image
On/Off