Great Plains PT8030 V1012 Operator Manual - Manual (Page 14)

12
Section 1 Assembly and Setup
10/10/12 PT6030 and PT8030 Pull-Type Planter 401-032M
Great Plains Mfg., Inc.
Mount First & Second State Assembly
Figure 1-2
12486
4. Install transfer links (#6) to pivot links and 2nd stage
mounts.
5. Start tractor and slowly extend one of the cylinders out
approximately 6 inches. Shut tractor off and by raising
the end of the 2nd stage attach the cylinder and the
pivot link. Check all hardware on the marker to speci-
fications then start tractor and fold marker to the stor-
age position.
6. Extend opposite cylinder approximately 6 inches.
Shut tractor off and repeat step 5.