Great Plains CTA4000 Predelivery Manual - Manual (Page 25)

Great Plains Manufacturing, Inc. Table of Contents Appendix Setup 21
2013-08-21 Table of Contents Appendix 160-037Q
Install Distribution Towers
Mount three towers on the center section and one tower
on each wing. Position towers so there is no interference
when wings are folded or unfolded.
General Tower Installation
Refer to Figure 26 and Figure 25
1.
Mount towers on frame tubes at dimensions shown
in Figure 25. To mount tower, mount support
bracket
on the frame using larger 4 ×5.2 inch
U-bolt , lock washers and
1 ⁄
2
-13 nuts .
Figure 25
Tower Mounting Positions
29340
(20.3 cm)
Figure 26
Mount Tower
16205
1
3
4
5
5
2
1
2 3 4