Great Plains CTA4000 Predelivery Manual - Manual (Page 16)

12 CTA4000 & CTA4000HD Table of Contents Appendix Great Plains Manufacturing, Inc.
160-037Q Table of Contents Appendix 2013-08-21
Hitching an ADC2350 Cart
ADC2350 Hitch Link
Refer to Figure 10,
which, for clarity, depicts the air cart without the rear hopper
1.
Use a line (not shown), from the cart walkboard, to
tie the cart links
up to the same height as the lug
holes .
2. Remove the pins near the ball swivel links of
the arms, allowing the arms to telescope. Do not
remove the stop bolts
.
3. Drive the roll pins out of the lug pins and
remove the lug pins.
4. Have a tractor slowly guide the cart backwards until
the link arm ball swivels are within two feet of the lug
holes
in the implement. Set tractor brake.
5. Manually extend each arm’s ball swivel into
alignment with the implement pivot holes . Insert
and secure the lug pins on the implement.
6. Slowly back the tractor up until the arm pins may
be reinserted. Secure them with clips.
7. Set tractor parking brake and shut off tractor.
ADC2350 Electrical Connections
Refer to Figure 11
Make sure tractor is shut down with accessory power off
before making connections.
1. Mate the lighting plug to the outlet connector on
the cart.
2. Mate the implement lift switch plug to the outlet
connector on the cart.
3. Mate the seed monitor plug to the outlet
connector on the cart.
4. Secure cables so they are clear of moving parts at
the hitch.
6
7
5
7
1
3
6
3
2
4
2
4
U
D
F
B
L
R
Figure 10
ADC2350-CTA4000 or CTA4000HD
Hitching
26431
1
5
2 3
4
6 7
5
3
5
7
2
Figure 11
ADC2350 Lighting & Monitor
26439
2
3
1
1
2
3