Great Plains CTA4000 Predelivery Manual - Manual (Page 11)

Great Plains Manufacturing, Inc. Table of Contents Appendix Assembly 7
2013-08-21 Table of Contents Appendix 160-037Q
Assemble Casters
Refer to Figure 4
1.
Using
5 ⁄
8
inch U-bolts, bolt side-arm braces to
center section as shown.
Two of these parts have decals on one face. These
are the rear arms, and when mounted, the decals
face to the rear.
Bolt rear brace parallel with welded frame tube .
Bolt front brace 23
1 ⁄
2
inches (59.7 cm) ahead of rear
brace. Secure braces with
5 ⁄
8
inch lock washers and
5 ⁄
8
-11 nuts.
2. Remove the retainer cap from the top of the
caster-wheel assembly. Make sure the thrust
washer
is on the caster . Roll the caster under
the mounting, and lower the mounting onto caster.
3. Bolt retainer cap back on top caster with removed
1 ⁄
2
-13 bolts and lock washers.
4. Using
5 ⁄
8
inch U-bolts, bolt lift-assist arm and
caster-wheel assembly onto side-arm braces.
Secure with
5 ⁄
8
inch lock washers and
5 ⁄
8
-11 nuts.
Bolt lift-assist arm to front frame tube using
5 ⁄
8
inch U-bolts, lock washers and nuts. Bolt lift-assist
arm to rear frame tube using
3 ⁄
4
inch U-bolts, lock
washers and nuts.
6
3
4
7
5
1
2
1
8
9
(59.7 cm)
U
D
F
B
L
R
Figure 4
Assemble Casters
17174
1
2
3
4 5
3
6
7
8