Wheatheart GHR 80/100 x 31-71ft Augers EMD - Manual (Page 30)

3. A SSEMBLY W HEATHEART - G RAIN A UGER EMD
3.10. T RANSPORT U NDERCARRIAGE GHR 80 X 31’-71’ & 100 X 31’-71’
30 30642 R0
9. Position transport
undercarriage
beneath tube
assembly and
attach lower reach
arms (Figure 3.18)
or extension arms
(Figure 3.17) to
reach arm bracket
on bottom tube with
5/8” x 1-1/2” bolts
and locknuts. Do
not overtighten.
Tighten snug only;
these bolts act as
pivot points.
¨
• The 8" x 56’-61’-71' and the 10" x 51’-61’-71' augers require 3/4” x 2" bolts
and locknuts.
¨
10. Add the Stabilizer
Kit to the following
augers:
• 8" x 56’-61’-71'
• 10" x 51’-61’-
71'
a. Attach short
cross-member
to small frame
brackets loosely
with two 1/2” x
1-1/2” bolts and
locknuts,
sandwiching the
flat braces (B)
between the
short cross-
member and small frame braces on each side (Figure 3.19).
b. Place undercarriage beneath the tube assembly, then position stabilizer
braces (A) as shown in Figure 3.20 and attach lower reach arms to reach
arm bracket welded on lower end of auger tube with two 3/4” x 2" bolts and
locknuts. Do not overtighten. Tighten snug only; these bolts act as pivot
points.
Figure 3.18
Figure 3.19