SARGENT L980A Keyed Removable Mullions - Manual

ADJUSTMENT OF MULLION
A) IF THE LATCHBOLT DOES NOT SNAP IN THE TOP RETAINER, REMOVE
MULLION AND TURN THE (2) SET SCREWS IN TOP RETAINER IN AND
REINSTALL MULLION.
B) IF TOP OF THE MULLION HAS EXCESSIVE AMOUNT OF PLAY, REMOVE
THE MULLION AND BACK OUT THE (2) SET SCREWS IN TOP RETAINER
AND REINSTALL THE MULLION.
C) WHEN TOP OF MULLION IS SECURE, TIGHTEN BOTTOM SET SCREW
ONLY ENOUGH TO REMOVE PLAY FROM THE MULLION.
Secure bottom retainer to surface of finished floor
with (3) three round head screws and anchors.
Secure top retainer to surface of top stop with (4) no. 14 x 1" flat head
wood screws or with (4) 1/4"-20 x 5/8" flat head machine screws
Determine the length of the mullion by cutting off at the bottom end
1-7/8" less than dim "x". This will give 1/8" clearance at top.
1
2
3
BOTTOM
RETAINER
DOOR DOOR
TOP
RETAINER
BOTTOM
RETAINER
TOP
STOP
FOR NARROW
TRANSOM
BARS USE
ADAPTER
DOOR
LATCHBOLT
MULLION
M
U
L
L
IO
N
THRESHOLD
STANDARD
M
U
L
L
IO
N
SET SCREW
FOR ADJUSTING
MULLION
BOTTOM
RETAINER
INSIDE OF
DOORS
SET
SCREWS
FOR
ADJUSTING
MULLION
LOCATED
INSIDE
RETAINER
DIM “X”
TOP
STOP
DOOR
INSTALLATION INSTRUCTIONS for
L980 Mullion
FOR ASSISTANCE CONTACT SARGENT AT 800-727-5477 or www.sargentlock.com
Copyright © 2009, Sargent Manufacturing Company, an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the express written
permission of Sargent Manufacturing Company is prohibited.
A7102D