SARGENT 58 - Electric Dogging - Manual

Installation and Wiring Instructions for
58- and 12-58- Prefix (Electric Dogging) 80 Series
Exit Device to ElectroLynx ® Connector System
For assistance, contact SARGENT at
800-810-WIRE (9473) or www.sargentlock.com
A. Function
When the 58-80 series exit device is energized and the rail is depressed, it will continuously hold the push rail
down and latch in an unlocked (dogged) position. When the device is de-energized (or power is interrupted), the
latch will extend.
B. Important
1. Caution: Disconnect all input power before beginning installation to prevent electrical shock and
equipment damage.
2. Installer must be a trained, experienced service person.
3. All wiring must comply with applicable local electrical codes, ordinances and regulations.
C. ElectroLynx Connector System Notes:
The system is designed to be installation friendly with
quick connectors from the electric hinge through the
door to the rail. The only wiring required is to the
loose wires on the pigtail harness assembly on the
frame side of the electric hinge.
IMPORTANT:
The plug and receptacle connectors are designed to
mate and lock together as shown in the figure. Plug
the connectors into each other with the locking
mechanism aligned as indicated.
Do NOT force connectors on any other way.
A6835C
1
58- 80 Series Rail with 8-pin connector
Red (+), 58 -
Black (-), 58-
1 7 5
6 4
3
2 8
Plug
Locking mechanism
Receptacle
Copyright © 2004, 2008, Sargent Manufacturing Company, an ASSA ABLOY
Group company. All rights reserved. Reproduction in whole or in part without the
express written permission of Sargent Manufacturing Company is prohibited.