SARGENT 1530 Series Standard Duty Overhead Concealed Mount - Manual (Page 4)

3
4
1
• Use the attached template that corresponds with the type of hinge being used
•
Drill and tap prepared metal door for channel and frame for jamb bracket. Fasten with
#12-24 machine screws provided
Friction adjustment on models
(1536F, 1537F, 1538F and 1539F) only
• To increase friction, insert flat bladed screw driver as shown
and turn clockwise until desired friction is attained
LEFT HAND SHOWN
Channel Jamb bracket
1
• Install channel into door (spring end towards hinge)
• Secure channel with fasteners provided
• Secure jamb bracket to frame with fasteners provided
2
Holding tension adjustment on hold open models only
(1536H, 1537H, 1538H and 1539H)
• To increase tension insert a 3/32” Allen wrench.
Turn clockwise as shown.
Spring end
Hinge
1536, 1537, 1538, 1539 SERIES
CONCEALED OVERHEAD HOLDERS & STOPS
INSTALLATION INSTRUCTIONS
NON-HANDED. LEFT HAND SHOWN, RIGHT HAND OPPOSITE.
FOR INSTALLATION ASSISTANCE, CONTACT SARGENT AT 800-727-5477 or www.sargentlock.com
A7500D
Copyright © SARGENT Manufacturing. All rights reserved.
Reproduction in whole or in part without the express written
permission of SARGENT Manufacturing is prohibited.
4
A7500D TEMPLATE 7487D