SARGENT 351 EHT/EHTD Electromechanical Closer-Holder - Manual (Page 4)

1
Left Hand
Shown
4
NOTE: AN AUXILIARY DOOR STOP IS REQUIRED AT HOLD OPEN
CAUTION:
1. DISCONNECT ALL POWER BEFORE INSTALLATION
2. ALL WIRING TO BE PERFORMED BY QUALIFIED PERSONNEL TO
COMPLY WITH ALL APPLICABLE LOCAL CODES.
3. MAXIMUM WIRE SIZE IS 18 AWG.
!
Use template from page 6 and drill and tap door and frame for 12-24 machine screws. Prepare hole for conduit.
Do not drill through channel, as damage will occur voiding warranty.
2
Install closer body to door with spring power nut away from hinge.
351 closers are non-handed, RH must be on top for right hand
doors, and LH must be on top for left hand doors.
LH
3
Attach conduit adapter to track with nut provided. Secure
cable or conduit (by others) per local codes.
4 Secure track to frame with electronics toward hinge with screws
provided. Install hole plugs into exposed holes in track. 5
6 7
Spring
Power
Nut
Wire through fire alarm contact
OR optional “Remote Release”
switch if used.
Connect 24VDC/VAC to terminal block
marked “+”, “-” AND “GND” (if applicable).
(NOTE: GND used if AC is used.)
+
-
G
N
D
On/Off
Switch
Rotate bottom spindle 45° with wrench. Use screw and washer to secure
main arm to top spindle with index mark as shown.
Hole Plug
Cover plate installed after wiring..
Fire alarm contact by
others or optional
remote release switch
Closer Spindle, Washer
and Screw
R. H. Door L. H. Door
Index
mark on
spindle
WARNING:
IF NOT PROPERLY INDEXED,
DOOR CLOSER WILL NOT
FUNCTION PROPERLY.
Index mark
on spindle
45° 45°
Hinge Hinge
A7655A
Copyright © 2009, Sargent Manufacturing Company, an ASSA ABLOY Group company. All rights reserved. Reproduction
in whole or in part without the express written permission of Sargent Manufacturing Company is prohibited.
INSTALLATION INSTRUCTIONS
351 EHT Electromechanical Closer-Holder Device –
Push Side
CAUTION: FAILURE TO INSTALL OR ADJUST PROPERLY MAY RESULT IN INJURY OR DAMAGE.
FOR ASSISTANCE CONTACT SARGENT AT 800-810-WIRE (9473) or www.sargentlock.com