Clarion NP401 - Manual (Page 51)

E
ng
lis
h
O
w
ne
r’s
M
an
ua
l
NP401 51
Button Description
If the Cursor is at or near a Pin, this
button replaces the previous one,
and deletes the Pin the Cursor is
near to.
The Cursor is appended at the end
of the route as the new destination.
The previous destination is
demoted, and becomes the last via
point.
This button is similar to the
button, but a new
screen opens, and the route is
calculated with all the possible
route calculation methods (Fast,
Short, Economical and Easy).
Observe the results, and choose
one of the routes to navigate.
The Cursor becomes the start
point of the route. This means
that the route is not started from
the current GPS position, and
Automatic Off-route Recalculation
needs to be turned off to keep the
selected point as the start point.
If the Cursor is at or near the
selected start point, this button
replaces the previous one and
deletes the start point from the
route. The current GPS position is
used again as the start point, and
Automatic Off-route Recalculation
is re-enabled.
Button Description
The Cursor is saved as a user POI.
Select the POI group and give
a name for the POI, then select
a suitable icon, enter a phone
number, and additional information
if you like.
The Cursor is saved as the location
of a Road Safety Camera (speed
camera or red light camera). A
new screen appears where you
can set the type of the camera, the
direction of the measured traffic,
and the speed limit checked for (if
applicable).
This button is not displayed when
GPS position is not available or if
you are in certain countries where
Road Safety Camera warning is
prohibited. Even if the button is
available, you are responsible for
checking whether it is legal to use
this feature at your location.
If the Cursor is at or near a Road
Safety Camera, this button
replaces the previous one, and
opens a new screen where you
can edit the details of the camera.
6.1.5 Position menu
When you follow the recommended route on the
map (the Cursor is the current GPS position), the
Position menu replaces the Cursor menu. It does
not contain buttons that modify the current route,
as the GPS position is not useful as a route point.
To open the Position menu, tap .
NP401 OM_100920_EN.indd 51 2011-1-6 16:10:59