Unitec Sentine Installation Manual - Manual (Page 22)

S E N T I N E L
Document Number: SENT1001 18
Document Name: Sentinel Installation Manual
4 System Startup
For fully detailed instructions, please see the Sierra Management Application
Programming Manual on the
www.StartwithUnitec.com website.
1. Power up the Sentinel.
2. Using a laptop, login into the Sierra Management System.
3. Enter the Site information and credit networking information, wash information, and
setup a device profile.
4. Download the device profile.
5. The Sentinel will reboot and be in full operational mode.
5 System Test
Once the installation is complete, a thorough test should be performed to ensure all
Sentinel functions are operational. This test should verify:
• Functionality of hardware devices (through diagnostic tests in maintenance
mode).
• Washes and added services are properly configured and wash outputs are
properly wired.
• The wash fault (out of service) signal places the Sentinel out of service.
• Sentinel Ethernet communications (through the Cat 5 cable).
• Credit card processing (Note: The merchant should confirm credit card
revenues are being properly deposited to their account).
• Functionality of peripherals (gate/gate controller, RFID Option, etc.).