Unitec Sentine Installation Manual - Manual (Page 11)

S E N T I N E L
Document Number: SENT1001 7
Document Name: Sentinel Installation Manual
2 Mechanical Installation
2.1 Hardware Required
Prior to beginning the installation, take the time to verify that all the following required parts are present
and accounted for.
Items supplied with the Sentinel:
• Allen Wrench For Door
• Key set for door
• Key set for vault door
• IEC-320-C14 Female AC Power Connector
Items supplied with the Base :
• (6) ½: Hex Nuts
• (6) ½” Flat Washers
• (6) ½” Lock Washers
2.2 Recommended Tools
2.2.1 Mechanical Installation Tools
The following tools are recommended for the typical mechanical installation of this Sentinel unit and base:
• ¾” deep well socket and socket wrench
• Open end 9/16” wrench
• Small, thin blade, flat-tip screwdriver
• Hammer
• Dual-plane Level
• 50’ foot tape measure
The following items may be required only when installing the Sentinel into an existing concrete slab:
• 2.5” Concrete hammer drill bit
• Saw or Pipe cutter (capable of cutting 2 in. diameter steel pipe)