Tweco Victor Thermal Dynamics Power Module Upgrade Kit - Manual (Page 3)

Manual 0-5326 3
4. On the opposite side locate the internal radiator. This will have to be extracted to make installation easier.
To do this on most models it will require two people
5. Remove the wires held in place by the plastic clips on the inboard side of the radiator, these hold in the power
cables for the fan to ensure they do not get caught in the fan props.
6. Remove the three M5 screws holding in the radiator in place
7. Gently lift the horizontal sheet metal shelf above the radiator to allow for clearance of the radiator fittings.
8. Tip the radiator out and set on the floor next to the unit. Ensure that none of the hoses become loose as they
will leak
Art # A-12325
CAUTION
The radiator is full of coolant and two people are recommended for removal. Care must be taken not to
damage the radiator fins. Damaged fins reduce the cooling capacity of the radiator.
9. Loosen one nut on each buss bar located behind the radiator. Depending on your level of upgrade there may
be more or less wires on the buss bars as shown below.
Art # A-12326