Tweco Victor Thermal Dynamics Power Module Upgrade Kit User Manual
Page 2
2
Manual 0-5326
Upgrade kit installation
NOTE
Most components not shown for clarity of installation. You will have to maneuver over, around and
through components to complete this installation. Disconnect all live power before starting procedure.
1. Remove side covers both the top and bottom on both sides of the machine.
Art # A-12323
2. Select appropriate blank center chassis plate(s) to be removed.
• for a 200A upgrade select just the center panel
• for a 300A or 400A upgrade select both the top and the middle
NOTE
For a 400A upgrade from a 300A system, the center inverter will have to be removed.
3. Remove the 4 screws holding in the panel and rock outward before pulling.
Art # A-12324
See also other documents in the category Tweco Hardware:
- Mini MIG Guns 160 Amp (1 page)
- ArcMaster 401MST (84 pages)
- ArcMaster 401S (64 pages)
- Eliminator Spool Gun (36 pages)
- Fabricator 252i (100 pages)
- Lightweight Quick Robotic Torch (23 pages)
- QCT-1 (18 pages)
- QFA600 (18 pages)
- QRC-2000 (26 pages)
- QRM-100 (16 pages)
- QRM-3 Anti-Spatter Sprayer (18 pages)
- QRP-IN TCP Check Tool (14 pages)
- Quick Fixed (27 pages)
- Quick Robotic Torch (40 pages)
- QWT-120 (16 pages)
- QWT-3 Quick Wire Trim Unit (16 pages)
- RDM-2000 (22 pages)
- SprayMaster with Velocity Consumables MIG Gun (12 pages)
- 181i (96 pages)
- 211i (96 pages)
- Fabricator 141i Operating Manual (104 pages)
- Fabricator 141i Quick Start (2 pages)
- Victor Torch Handles,Cutting Attachments (94 pages)
- Single & Two Stage Regulators (68 pages)
- 7-3431 (2 pages)
- 7-3436 (2 pages)
- 7-3437 (2 pages)
- 7-3438 (2 pages)
- 7-3439 (2 pages)
- 7-3440 (2 pages)
- 7-3441 (2 pages)
- 7-3442 (2 pages)
- 7-3443 (3 pages)
- 7-3444 (1 page)
- 7-3445 (4 pages)
- 7-3446 (2 pages)
- 7-3448 (2 pages)
- 7-3449 (3 pages)
- 7-3450 (1 page)
- 7-3480 (2 pages)
- 7-3482 (2 pages)
- 9-1001 (1 page)
- 9-8311 (3 pages)
- 9-9385 (4 pages)
- 9-9417 (12 pages)