Tweco SL100 RPT - Manual (Page 13)

June 6, 2003 13 Manual 0-2937
Standard Torch Control Cable for Start / Stop Only Mechanized Systems
A-03428
Torch Control
Cable
To Power Supply
Control Connectors
Torch
Adapter
To Torch
Control Device
Torch Control
Connectors
Torch Lead Assembly
Pilot Lead
Not Used
Optional Torch Control Cable For CNC / Remote Pendant Systems
Torch Control
Connectors
Torch Lead
Assembly
A-03426
Control Connector
Plug with Connectors
To Power Supply
Control Connector
To Torch
Control Device
Torch Control
Cable
Pilot Lead
Torch
Adapter
NOTE
Leads are available only for Thermal Dynamics Product and are not to be installed on any other products.
WARNING - Replacing Original Machine Torch with TDC RPT Mechanized Torch
Thermal Dynamics RPT Mechanized torches have two control wires that are used for Parts - In - Place only. Do not
connect these connections directly into any start input, because when the torch parts are in place, the start signal
will always be energized. If the torch parts are not in place but are subsequently installed with the start signal
energized, the shield cup will complete the start circuit and the unit will immediately start a pilot arc.
NOTE
Every effort has been made to provide complete and accurate information in this manual. However, the
publisher does not assume and hereby disclaims any liability to any party for any loss or damage caused
by errors or omissions in this Manual, whether such errors result from negligence, accident, or any other
cause.