Tweco SL100 RPT - Manual

June 6, 2003 1 Manual 0-2937
Manual 0-2937
Model SL100 RPT
Replacement Plasma Cutting
Machine Torches
Installation and Operation Instructions
Options
The following options are available. Refer to the parts
lists for catalog numbers.
• ATC Adapter Kit (for Torches with ATC connections)
• Leads extensions (for Torches with ATC connections)
• Leather Leads Covers
• Ohmic Clip Kit
• Pinion
• 5" / 127 mm Positioning Tube
Torch Specifications
A. Torch Configuration and Dimensions
The Torch is available with mounting tube with rack and
pinch block assembly.
A-02998
1.375" / 35 mm
15.875" / 403 mm
0.625" / 16 mm
4.95" / 126 mm
1.175" / 30 mm
9.285" / 236 mm
© 2002 by Thermal Dynamics Corporation, Printed in USA
General Information
The SL100 SureLok ® Torch works with most plasma cut-
ting power supplies. The Torch is equipped with either
O2B connectors or the Thermal Dynamics ATC connec-
tor. Installation requires an Adapter Kit sold separately.
The Torch provides cutting capabilities of up to 100 am-
peres. The torch uses compressed air as both the plasma
and secondary gas. Single - gas operation provides a
smaller torch and inexpensive operation.
Refer to the Complete Assembly Replacement page for
configurations and catalog numbers.
These instructions are important for the proper installa-
tion of the Torch. Read the instructions thoroughly be-
fore attempting the installation. Keep these instructions
for reference.
Supplied Parts
The Replacement Torch kits include:
• Torch With Leads - 1 each
• Installation Instructions - 1 each
• Consumables (SureLok MaximumLife TM Electrode,
Starter Cartridge, Tip, and Shield Cup)
NOTE
The consumable parts installed in the Torch may
not necessarily be optimized for your Power Sup-
ply or cutting application.
For best results, refer
to the selection chart in this manual to choose the
proper consumables.
82 Benning Street, West Lebanon, NH 03784 USA
(603) 298-5711 • www.thermal-dynamics.com