Tweco 185TSW DC CC User Manual
Inverter arc welder
This manual is related to the following products:
Table of contents
Document Outline
- SYMBOL LEGEND
- STATEMENT OF WARRANTY
- 1.0 GENERAL INFORMATION
- 2.0 INTRODUCTION AND DESCRIPTION
- 3.0 Installation Recommendations
- 4.0 OPERATOR CONTROLS
- 5.0 SET-UP FOR SMAW (STICK) AND GTAW (TIG)
- 6.0 SEQUENCE OF OPERATION
- 7.0 BASIC TIG WELDING GUIDE
- 7.01 Explanation of “Fluttery Arc” when AC TIG Welding on Aluminum
- 7.02 Electrode Polarity
- 7.03 Tungsten Electrode Current Ranges
- 7.04 Tungsten Electrode Types
- 7.05 Guide for Selecting Filler Wire Diameter
- 7.06 Shielding Gas Selection
- 7.07 TIG Welding Parameters for Low Carbon & Low Alloy Steel Pipe
- 7.08 Welding Parameters for Aluminum
- 7.09 Welding Parameters for Steel
- 8
- 8.0 Basic Arc Welding Guide
- 9.0 ROUTINE MAINTENANCE
- 10.0 BASIC TROUBLESHOOTING
- 11.0 Voltage Reduction Device (VRD)
- 12.0 Power Source Error Codes
- 13.0 PARTS LIST
- A
- APPENDIX A – INTERCONNECT DIAGRAM
- APPENDIX B - AUTOMATION