tekmar 512 Programmable Thermostat User Manuals User Manual

Page 3

3 of 8

U 512 - 09/09

SETTING THE TEMPERATURE(S)

A separate heating temperature can be set for each event of the schedule. If a slab sensor
is connected to the control, a separate minimum slab temperature can be set for each
event of the schedule.

Use the following procedure to set each temperature.

Step One: Press and release the

Menu

button until the Adjust Menu is reached.

Step Two: Press and release the

Item

button until the desired temperature is displayed.

Step Three: Use the

button to set the desired temperature. Record this temperature

in the schedule table found on page 7.

Repeat steps two and three for each additional temperature.

SETTING THE TIME

Step One:

Press and release the

Menu

button until the Time Menu is reached.

Step Two: Press

the

Item

button. While the minutes are flashing, use the

button to set the proper minutes.

Step Three: Press and release the

Item

button. While the hours are flashing, use the

button to set the proper hour.

Step Four: Press and release the

Item

button. While the day is flashing, use the

button to set the proper day.

SETTING THE SCHEDULE

A schedule allows the thermostat to automatically change between several preset
temperatures based on the time of day. The schedule divides the day into either two or four
events. For each event, a different temperature can be set. This allows the room and / or
floor to be warm during the day and cooling during the evening and night.

To set the time of day at which each event is to begin, use the following procedure.

Step One:

Press and release the

Menu

button until the Schedule (SCHD) Menu is

displayed.

Step Two:

Press and release the

Item

button. Use the

button to select

the desired schedule Mode. None = one temperature per day. 2 = two
temperatures per day. 4 = four temperatures per day.