tekmar 507 Thermostat Installation - Manual (Page 7)

7 of 8 © 2010 D 507 - 05/10
View Menu
ROOM TARGET
The current desired air temperature for the space as set in the Adjust
Menu.
Adjust Menu
MODE
Current mode of operation of the thermostat.
OFF, HEAT
Error Messages
E01
The thermostat was unable to read a piece of information stored in
its memory. The thermostat was required to load the factory settings.
The thermostat will stop operation until all settings are checked. To
clear this error, check all of the settings in the Adjust menu.
ROOM
The current air temperature for the space.
ROOM HEAT
Desired temperature for heating. (Mode must be set to HEAT.)
35 to 100°F (1.5 to 38.0°C)
UNITS
The units of temperature used to display the items.
°F, °C
ROOM SHORT
The thermostat’s internal air sensor is short circuit. This cannot be
repaired in the field. The thermostat should be replaced or returned
for repair.
ROOM OPEN
The thermostat’s internal air sensor is open circuit. This cannot be
repaired in the field. The thermostat should be replaced or returned
for repair.