Citizen Systems CLP-8301 - Manual (Page 57)

Chapter 6 Configuring Your Printer Using the Menus
- 48 -
6.8 Menu Mode Description
Group Menu Menu Item Default Value Range of Values Description
Label Width 8.53in
216.7mm 3.00
- 8.64in
76.2
- 219.5mm
Set print label width.
Print Speed 04 IPS 02
- 04 IPS ¾
Print Darkness 10 00 - 30* *When language is DDP-N3, the
maximum value is 20.
* Page Setup
Print Method TT DT / Direct Thermal
TT / Thermal Transfer Set printing method.
Ribbon Torque 3 1 - 5 Set ribbon winding torque
Continu. MediaLen 10.00in
254.0mm 0.25
- 40.00in
6.4 - 1016.0mm
Set print label length
Vertical Position 0.00in
0.00mm - 1.00 - 1.00in
-25.4 - 25.4mm
Adjust print start position.
Horizont Shift 10.00in
254.0mm - 1.00 - 1.00in
-25.4
- 25.4mm
Adjust left-to-right position in dots.
Media Sensor See Thru See Thru
Notch
Reflect White
Reflect Blue
None Select label sensor.
See Thru: Transparent GAP sensor.
Notch: Transparent HOLE sensor.
Reflect White: Reflective White base
sensor.
Reflect Blue: Reflective Blue base
sensor.
None: No use of sensor (continuous
paper)
Sensor Monitor
¾
x.xV adc Monitor media sensor sensing level.
When None, See Thru (GAP) sensor
sensing level is monitored.
Sensor Level 1.5V/1.7V 0.0V - 3.3V Set sensor threshold.
Top Form Yes Yes
No Select Top-Of-Form (TOF) sensing.
Printer will feed to top-of-form before
first print after power on.
Buzzer Select Exec/Err Exec/Err
All
Error
Key
None Select condition for buzzer.
Exec/Err: Sounds when setting and
execution are completed or error
occurs.
All: Sounds in all situations.
Error: Sounds only in error.
Key: Sounds in key operation.
None: No sound.
Metric/Inch Inch Inch
mm
Set basic unit of measurement to
millimeters or inches.
Print Res. DPI
(Print Res. DPmm) 300
300DPI(12 DPmm)
150DPI(6 DPmm) Set print resolution.
Values in parentheses are in metric
system.
AutoCal Mode Perform sensor calibration.
* System Setup
MaxMedia Length 10.00in
250.0mm 1.00 - 50.00in
25.4mm - 1270.0mm
Set GAP length.
(continued)