Citizen Systems CLP-8301 User Manual

Page 33

Chapter 4 Media (Paper) and Ribbon

----

Two ribbon bobbins are used for loading ribbon; one is inserted in the source (unused) ribbon core

and the other is inserted in the destination ribbon core. And wind ribbons two or three times around

the destination ribbon core by hand.

NOTE

The following procedure may help you load the ribbon more easily. First insert the bobbins

into the source and destination ribbon cores, affix the adhesive tape at the end of the ribbon

and then wind the ribbon around the bobbin until the tape is hidden. Finally, set the ribbon by

passing it through the lower side of the printhead assembly.

CAUTION

Be sure to wind the ribbon sufficiently over the adhesive clear tape fastened to the end of the

ribbon.