Citizen Systems CLP-8301 - Manual (Page 39)

Chapter 4 Media (Paper) and Ribbon
---- 30 ----
3 When the media being used is a center-punched hole or corner-with-a-radius cut tag, first align the T
mark (in proximity to two light-emitting devices) with the holes or cuts on the tag (at this time, read the
scale), then lower the transparent sensor guide fully to the end and push it to lock and move the
transparent sensor to the scale same as read before.
4 The media sensor adjustments are now completed. Lastly return the printhead assembly and top
cover to their original position.
Transparent sensor
(light-receiving device)