Kessler MOTION CONTROL: Second Shooter - Manual (Page 8)

4. Set the RAMP value by selecting with Enter and adjusting with the Up and Down
arrows:
• Ramp – Percentage value indicates the change in speed of the movement over the entire
move. The frame value to the right shows how many images until the system gets up to the
top speed or how many images until the camera comes to a stop.
5. Select START to begin the time-lapse.
The motors will move into the start position (1st key frame) and the backlight will turn off. Press
the Shift button to toggle the backlight on/off. Press the Enter button to Pause/Resume the time
lapse move.
Stop Motion
1. Set values for #PHOTOS & RAMP:
• #Photos - Indicates the number of photographs taken during the entirety of the move
• Ramp – Percentage value indicates the change in speed of the movement over the entire
move. The frame value to the right shows how many images until the system gets up to the
top speed or how many images until the camera comes to a stop.
2. Select
AUTO ADVANCE
or
MANUAL ADVANCE
by pressing Enter to toggle
selections.
• Auto Advance - In this mode, after the camera fires, the system will automatically advance
to the next position in the movement
• Manual Advance - After firing the photo, you will hit Left or Right to move the camera into
the next/previous position in the move
3. Select NEXT by pressing Enter.
4a. Select
SNAP
to trigger the camera and repeat for auto advance.
4b. Select
SNAP
to trigger the camera. Press the Left or Right arrow to move the
camera into the next/previous position for manual advance. Repeat.
8