Kessler MOTION CONTROL: Second Shooter User Manual

Page 7

Now choose one of the following shooting modes:

•

LOOP/SCRUB

•

TIME LAPSE

•

STOP MOTION

Loop/Scrub

1. Set

TIME

and

RAMP

values by selecting with Enter and adjusting with the Up and

Down arrows:

• Time –

The amount of time it will take to complete entire move

• Ramp –

Percentage value indicates the change in speed of the movement over the entire

move. The time value to the right shows how fast/slow the system gets up to the top speed

or how fast/slow the camera comes to a stop.

1. Press ENTER to select

RUN.

• Scrubbing –

Press ENTER while Looping to enter SCRUB mode. This feature will allow

you to manually advance the position of the Slide, Pan & Tilt axis within the programmed

move by holding the LEFT or RIGHT arrow button.

Time Lapse

1. Select

SHOOT/MOVE/SHOOT

CONTINUOUS

mode:

• Shoot/Move/Shoot –

Camera will only fire when not moving. That is, the camera will fire,

move to next position, stop and fire.

• Continuous –

Camera will move without stopping and fire throughout the duration of the

move

*If using a 3rd party intervalometer, select Continuous and set the overall run time by increasing

or decreasing the Photos value. The exposure, delay and photo values will not be used.

Fig. A