GBC 2064WF User Manual

Page 23

GBC 2064WF-1

Operation Manual

APPLICATIONS

TRAILOR BOARD

LEADER BOARD

BOARDS

MOUNT

ADHESIVE

PRE-COATED BOARD

IMAGE

RELEASE LINER

ROLL TO ROLL OPTION

IMAGE

RELEASE LINER FROM PSA FILM

OUTPUT

KRAFT
PAPER
OPTION

MOUNT

ADHESIVE

Tips for Pre Coating Boards

1. Load the laminator as illustrated in (Fig. 30).

Remove chill idler.

2. The width of the roll should not exceed the

width of the board by more than 1/2 in. (1.3
cm).

3. Use a leader board to set the main roller and

pull roller pressure prior to webbing.

4. Use a leader board to start the run and a trailer

board to finish the run.

5. Using the pull rollers will allow you to leave

gaps between boards.

6. If not using the pull rollers, have the boards

nearby to butt end to end during feeding.

Tips for Mounting Pre Coated Boards

1. Use a leader board to set the main roller

pressure prior to mounting the image.

2. Ensure the chill idler is removed and the rear

slitter is to one side.

3. Do not stop once you have started the mounting

process through the machine. (Fig. 31)

Note: This application can also be performed from
the rear operating position. Reference Fig. 34 for
Illustration.

Tips for Single Sided lamination

1. Load the laminator as illustrated in Fig. 32.

2. Use kraft paper for one-sided lamination When

ever the items to be laminated are narrower than
the film you are using.

3. If not using kraft paper, use a scrap piece to

finish the run or you will have adhesive on your
rollers.

4. For high volume runs, use Kraft paper and the

lower rear rewind for roll to roll operation.

5. Running the web over the chill idler may

improve the Flatness of the output.

6. A little heat,125 degree F (52 degree C),may

help eliminate silvering effects associated with
PSA films.

FIGURE 30

FIGURE 31

FIGURE 32