E-flite Eratix 3D 25e ARF - Manual (Page 27)

2 E-flite Eratix 3D 25e ARF Assembly Manual
 6. Plug the elevator servo, rudder servo and ESC into the
receiver. Mount the receiver to the inside of the fuselage
using hook and loop material. Route the antenna wire
through the bottom of the fuselage to the rear, or as
directed by your radio instruction manual.
Note: Do not cut or change the length of the antenna
wire, as this will reduce the range of your radio system.
Control Throws
 1. Turn on the transmitter and receiver of your aircraft.
Check the movement of the rudder using the transmitter.
When the stick is moved right, the rudder should also
move right. Reverse the direction of the servo at the
transmitter if necessary.
 2. Check the movement of the ailerons using the
transmitter. When the stick is moved right, the right
aileron will move up and the left aileron will move
down. Reverse the direction of the servo at the transmitter
if necessary.
 3. Check the movement of the elevator with the radio
system. Moving the elevator stick down will make the
airplane elevator move up.
 4. Use a throw gauge to adjust the throw of the elevator,
ailerons and rudder. Adjust the position of the pushrod
at the control horn, or the travel/endpoint adjustments
of your computer transmitter, to achieve the following
measurements when moving the sticks to their endpoints.