E-flite Eratix 3D 25e ARF - Manual (Page 20)

20 E-flite Eratix 3D 25e ARF Assembly Manual
 2. Remove the hatch from the fuselage. Slide the wing
panel with tube into position on the fuselage.
  3. Slide the remaining wing panel into position. Secure
the panels using 4-40 x 1 /
2
-inch machine screws with #4
washers (silver) using a 3/32-inch hex wrench.
  4. Repeat Steps 2 and 3 for the remaining wing panel.
Stabilizer and Elevator
Required Parts
• Fuselage w/wing installed
• Stabilizer • Elevator
• CA hinge (4) • Elevator joiner wire
Required Tools and Adhesives
• Hobby knife • Felt-tipped pen
• Ruler • T-pins
• Thin CA • Sandpaper
• 30-minute epoxy
 1. Position the stabilizer into the slot in the aft end
of the fuselage. Check that the stabilizer is centered
in the fuselage.