E-flite Eratix 3D 25e ARF - Manual (Page 10)

10 E-flite Eratix 3D 25e ARF Assembly Manual
  2. Slide the 4mm x 35mm machine screw through one of
the 2 3 /
4
-inch wheels. Secure a 4mm lock nut against the
wheel. Make sure the wheel still spins freely.
  3. Attach the wheel to the landing gear using a
4mm washer and a 4mm lock nut. Leave the nut
loose at this time.
  4. Slide the wheel pant over the wheel. The 4mm washer
will be inside the wheel pant. Use two 2mm x 8mm sheet
metal screws threaded into the pre-drilled holes to attach
the wheel pant to the landing gear. Tighten the 4mm lock
nut using a 7mm nut driver to complete the assembly.
 5. Repeat Steps 2 through 4 for the remaining wheel
and wheel pant.