E-flite Eratix 3D 25e ARF - Manual (Page 23)

23 E-flite Eratix 3D 25e ARF Assembly Manual
  8. Prepare two CA hinges by placing a T-pin in the
center of each hinge. Test fit the elevator against the
stabilizer. Make sure the joiner wire fits into the elevator
as well.
  9. Rougher the joiner wire using medium grit sandpaper.
Apply 30-minute epoxy to the joiner wire and in the hole
in the elevator as well.
  10. Follow the same procedure for hinging the ailerons to
hinge the stabilizer/elevator.
 11. Repeat Steps 8 through 10 for the remaining
elevator.