E-flite Eratix 3D 25e ARF - Manual (Page 14)

1 E-flite Eratix 3D 25e ARF Assembly Manual
Aileron Installation
Required Parts
• Wing • Receiver
• Servo w/hardware (2) • Long servo arm (2)
• CA hinge (8)
• Clevis (2) • Clevis retainer (2)
• Nylon control horn (2) • 3mm x 30mm machine screw (2)
• Control horn standoff (2) • Control horn washer (2)
• 2 7 /
8
-inch (73mm) pushrod wire (2)
• Pushrod wire connector (2)
Required Tools and Adhesives
• Rotary tool • Drill bit: 1/16-inch (1.5mm)
• T-pins • Thin CA
• Felt-tipped pen • Pen drill
• Threadlock • Side cutters
• #1 Phillips screwdriver
  1. Locate four CA hinges. Place a T-pin in the center of
each hinge.
  2. Use a rotary tool and a 1/16-inch (1.5mm) drill bit
to drill a hole in the center of each hinge slot of both the
aileron and wing. This provides a tunnel for the CA to
wick into, penetrating the hinge.
Hint: You can prepare the rudder, fin, elevator and
stabilizer at this time as well.
  3. Slide the four hinges into the slots in the aileron.