E-flite Eratix 3D 25e ARF - Manual (Page 15)

15 E-flite Eratix 3D 25e ARF Assembly Manual
  4. Slide the aileron into position on the wing. The
T-pins installed in the hinges will help in keeping
equal amounts in the wing and aileron.
  5. Align the aileron with the wing tip. Apply a few drops
onto each hinge. Make sure to apply the CA on both the
top and bottom of the hinge.
Important: Do not use accelerator on the hinges. The CA
must be allowed to soak in and penetrate the hinge.
Note: Placing a #11 hobby blade between the aileron
leading edge and wing trailing edge to position the
aileron will result in a nice free-moving hinge for 3D
throws without any binding.
  6. Gently pull the aileron from the wing once the CA has
fully cured. This is to verify the hinges are glued securely.