E-flite Eratix 3D 25e ARF - Manual (Page 25)

25 E-flite Eratix 3D 25e ARF Assembly Manual
Rudder and Elevator Servos
Required Parts
• Fuselage
• Long servo arm (2) • Servo (2)
• Clevis (2) • Clevis retainer (2)
• Nylon control horn (2) • 3mm x 30mm machine screw (2)
• Control horn standoff (2) • Control horn washer (2)
• 4-inch (102mm) pushrod wire
• 5
1 /
2
-inch (140mm) pushrod wire
• 12-inch (305mm) servo extension (2)
• Pushrod wire connector (2)
Required Tools and Adhesives
• Phillips screwdriver (small) • Hobby knife
• 30-minute epoxy • Threadlock
• String or dental floss
  1. Secure a 12-inch (305mm) servo extension to the
servo. Mount the elevator servo using the hardware
provided with the servo.
Note: Use string or dental floss to secure the servo lead
to the servo extension so they don't become unplugged
during flight.
  2. Attach the control horn in position on the rudder
and elevator using the same technique as the aileron
control horns.
Note: Use threadlock on the control horn screw to
prevent it from vibrating loose.