E-flite Eratix 3D 25e ARF - Manual (Page 24)

2 E-flite Eratix 3D 25e ARF Assembly Manual
Rudder and Fin
Required Parts
• Fuselage • Rudder
• Fin • CA hinge (3)
• Tail wheel assembly • Tailwheel
• Wheel collar w/setscrew
Required Tools and Adhesives
• Hobby knife • Thin CA
• 30-minute epoxy • Medium grit sandpaper
• Hex wrench: 1.5mm
 1. Roughen the tail wheel assembly using medium grit
sandpaper. Use 30-minute epoxy to glue the tail wheel
assembly into the fuselage.
 2. Hinge the rudder and fin, using the same process
as described in Aileron Hinging. Use three hinges for
this process. Make sure to install the tail wheel into the
rudder as well, gluing it with 30-minute epoxy.
 3. Install the tail wheel using the wheel collar
and setscrew. Use a 1.5mm hex wrench to tighten
the setscrew.