E-flite F-86 Sabre 15 DF ARF - Manual (Page 9)

9 E-flite F-86 Sabre 15 DF ARF Assembly Manual
 14. Use a hobby knife and #11 blade or hobby
scissors to trim the aileron servo cover. Lines have
been embossed on the cover to be used as a guide.
Make sure the opening for the linkage is angled
slightly so the linkage doesn’t bind on the cover.
 15. Use the tape provided with the model to attach
the cover to the wing. Make sure the aileron servo
can operate without having the linkage binding on
the cover.
 16. Apply the decal to the servo cover. Take your
time to fit the decal to the contours of the cover.
 17. Repeat Steps 1 through 16 to install the
remaining aileron linkage and servo cover.
Cut the portions of the letters from the decal
sheet to apply to the cover to complete
the form of the covered letters.
Mounting the Main Wing Panels
Required Parts
Left wing assembly Right wing assembly
Carbon wing rod, 9-inch (230mm)
Carbon wing rod, 13-inch (330mm)
Fuselage assembly
Required Tools and Adhesives
12-minute epoxy Mixing cup
Mixing stick Epoxy brush
Paper towel Rubbing alcohol
Low-tack tape Sandpaper
Sanding Bar
 1. Remove the shipping tape that holds the canopy
to the fuselage.