E-flite F-86 Sabre 15 DF ARF User Manual

Page 11

E-flite F-86 Sabre 15 DF ARF Assembly Manual



7. Repeat Steps 1 through 6 to prepare the

opposite side of the fuselage for the wing.



8. Apply a thin layer of 15-minute epoxy to the

fuselage where it was sanded previously.



9. Apply a thin layer of 15-minute epoxy to the

short and long wing rods before you insert them

into the wing.



10. Apply a thin coat of 15-minute epoxy on the

end of the wing that will butt against the fuselage.



11. Slide the wing into position against the

fuselage. Use low-tack tape to keep the wing tight

against the fuselage until the epoxy fully cures.



12. Repeat Steps 8 through 11 to install the

remaining wing panel to the fuselage.



13. Before the epoxy cures, use a paper towel

and rubbing alcohol to remove any excess epoxy

that may have oozed out from the joint between

the wing and fuselage.