E-flite F-86 Sabre 15 DF ARF - Manual (Page 35)

35 E-flite F-86 Sabre 15 DF ARF Assembly Manual
Canopy Assembly
Required Parts
Canopy hatch Cockpit
Clear tape Pilot figure (optional)
Required Tools and Adhesives
Hobby scissors
 1. Use hobby scissors to trim the cockpit along the
molded lines.
 2. Insert the cockpit in the canopy hatch. It is best
to insert the front first, then the rear will fit right in.
 3. Use clear tape to hold the cockpit in the
canopy hatch.
Optional Pilot
You may notice a pilot shown in the F-86 Sabre. A
pilot is not included with the kit. It can be purchased
separately under part number (PKZ7003). The pilot
was cut down to fit and was glued in with canopy
glue as shown before the cockpit was installed in the
canopy hatch.
Motor Battery Installation
Required Parts
Motor battery Hook and loop tape
Assembled airframe
Canopy hatch assembly
Required Tools and Adhesives
Hobby scissors
 1. Cut a piece of hook and loop tape that is
4 1 /
2
inches (115mm) long. Apply the tape to the
intake tube so it is centered on the top of the tube
and positioned equally forward and backward of
the intake mounting plates.
 2. Apply the mating portion of the tape to the
bottom of the motor battery as shown.