E-flite F-86 Sabre 15 DF ARF - Manual (Page 24)

24 E-flite F-86 Sabre 15 DF ARF Assembly Manual
 10. Slide a pushrod connector on the 19
11
/
16
-inch
(500mm) pushrod wire.
 11. Insert the pushrod wire into the outside hole of
the control horn. Slide the rudder pushrod in the
hole of the pushrod connector. Use pliers to open
the pushrod keeper just enough to slip it over the
bend of the pushrod wire so it secures the pushrod
wire to the control horn. Don’t open the connector
too far as it could possibly break the connector.
 12. Center the rudder and the rudder servo. Use a
2mm x 4mm machine screw to secure the pushrod
wires in the pushrod connector. Use a #1 Phillips
screwdriver to tighten the screw. Use side cutters
to trim the excess length of the pushrod wire so it
does not interfere with the operation of the servo.
Landing gear Installation
Required Parts
Nose gear wire Wheel collar (7)
Main gear wire, left
Main gear wire, right
3mm x 3mm setscrew
Landing gear strap (2)
Nose gear steering arm
2mm x 8mm machine screw (7)
Nose wheel, 1
3 /
16
-inch (30mm)
Main wheel, 1 5 /
8
-inch (41mm) (2)
2mm x 8mm sheet metal screw (4)
Required Tools and Adhesives
Phillips screwdriver: #1
Hex wrench: 1.5mm Threadlock
 1. Insert the main landing gear into the notch in
the wing. The wire will fit flush with the wing when
installed. There is a left and right main gear wire.
When positioned correctly the spring coil will face
the rear as shown in the photos.