E-flite F-86 Sabre 15 DF ARF - Manual (Page 29)

29 E-flite F-86 Sabre 15 DF ARF Assembly Manual
 5. When installing a remote receiver, attach it as
shown in the fuselage using hook and loop tape.
Intake Tube Installation
Required Parts
Assembled airframe
Intake tube
Hook and loop strap
 1. Remove the cover from the bottom of the
fuselage and set it aside in a safe location.
 2. Prepare the hook and loop strap by attaching
the pieces together using a 2-inch (52mm)
overlap as shown.
 3. Locate the intake tube. The circular end will fit to
the rear of the fuselage. The front is egg-shaped to
match the intake of the fuselage and the flatter side
will face to the bottom of the fuselage.
 4. Place the hook and loop tape on the intake tube
at this time. This will prevent you from accidentally
looping the tape around the steering linkage wire.