E-flite F-86 Sabre 15 DF ARF - Manual (Page 27)

27 E-flite F-86 Sabre 15 DF ARF Assembly Manual
 4. Insert the steering pushrod in the hole of the
servo arm. Position the servo so the nose gear is
aligned with the fuselage centerline so it will taxi
straight down the runway. Use a felt-tipped pen to
mark the fuselage where the servo rests.
 5. Lightly sand the seam in the fuselage where the
steering servo rests. This provides a flat area for the
mount to be glued.
 6. Use 6-minute epoxy to glue the servo mount in
the fuselage. Once the epoxy fully cures, secure
the servo using the servo mounting strap and two
2.5mm x 10mm sheet metal screws. Tighten the
screws using a #1 Phillips screwdriver.
Check to make sure the nose gear wire
can move freely so the steering servo is not
overloaded when trying to steer your aircraft.
Speed Control and
Receiver Installation
Required Parts
Assembled airframe
Speed control
Receiver
Hook and loop tape
Required Tools and Adhesives
Hobby scissors
 1. Cut a piece of hook and loop tape and apply it
to the bottom of the speed control as shown. Leave
the adhesive backing on the mating hook and loop
until instructed to do so.
 2. Remove the backing from the hook and loop
tape on the speed control. Secure the speed control
inside the fuselage as shown.