E-flite P-47D Thunderbolt 400 ARF - Manual (Page 30)

Inrunner Motor Installation
Park 400
Required Parts
• 11x7 propeller • Assembled airframe
• 10-tooth 0.5 module pinion gear
• 65-tooth 0.5 module spur gear
Required Tools and Adhesives
• Wrench • Foam-safe CA
• Drill • Drill bit: 5/32"
Note: This section covers installing the stock
gearbox and optional Park 400 inrunner motor.
Skip to the next section if you have opted to
install the optional outrunner motor.
 1. It may be necessary to attach motor adapters
or other accessories to your particular motor at
this time. Use the instructions provided with your
motor to install any accessories.
 2. Install the 10T 0.5 module pinion gear on your
motor if you are using our included gearbox.
Using any pinion gear other than the optional
10-tooth 0.5 module pinion gear (EFLM1951)
will cause damage to the spur gear.
 3. Remove the 56-tooth spur gear by sliding it off
the shaft. Slide the optional 65-tooth 0.5 module
spur gear (EFLM1243) onto the shaft.
Note: You will need to install the upper motor
mounting screw with the spur gear removed.
30